Set the reference state
Specify whether the part is measured on the carrier or after removal, along with what supports it. Avoid pressing or stretching the sample unless the agreed method calls for it.
Mark reference points on the drawing and distinguish an outer envelope from a local width. A curved outline may need a different check from a straight side.
Choose a suitable record
For visual overlays, retain a properly scaled image and document what it compares. For dimensional data, record the tool and measurement result against each dimension.
Check whether different reviewers obtain similar readings from the same sample. If results disagree, investigate alignment and how the part is supported.
Agree how results will be used
Tie the measurement result to the agreed tolerance and the sample identifier. Record any issue that changes the review state before drawing a conclusion.
Keep appearance notes separate from dimensions so a buyer can decide whether a visual deviation and a measurement finding represent the same concern.
Frequently asked questions
Is a phone photo sufficient for dimensional acceptance?
It can document an observation. Use an agreed calibrated reference or measurement method for a released dimension.