• Custom shape feasibility
  • Drawing and liner review
  • Prototype acceptance planning

Review patch curl when a sample leaves its pack

A patch that looks curved on the bench may already have been curved in the pack. To discuss the next change with a converter, record when the shape first shifts and how the sample was supported at that moment.

Observe each opening stage

Start with a photo of the unopened unit and its identifier. Open the pack in its intended orientation. Capture the carrier in the tray, the carrier on a flat surface and the patch after release. Use the same viewing direction and note the time of each observation. If one end lifts, identify it on the drawing so later reviewers can refer to the same point.

Choose the comparison sample

Request another unit packed in the same orientation and review it under the agreed conditions. Compare end position, visible creases and handling across the two units. If the buyer wants to explore a different tray, agree what other elements will stay constant for the next comparison. Record whether the observed curl affects pickup, placement or pack clearance so the supplier knows what outcome matters.

Frequently asked questions

Should the reviewer flatten the patch before photographing it?

Take an initial view as received. If a later comparison requires flattening, record the support and handling used for that second view.

References

Share this requirement with our team

Share the proposed outline, target areas, drawing revision and any prototype acceptance criteria.