• Custom shape feasibility
  • Drawing and liner review
  • Prototype acceptance planning

Smile-Line Patch Pair Geometry

A narrow curved patch may look reversible on a drawing. Its point, peel tab and curve can make it a handed part once it is packed.

Decide whether the parts are handed

Draw both outlines on the same coordinate grid and mark the intended left and right sides. Indicate whether the geometry or printed directions determine placement.

If the parts are mirror images, verify the orientation of the cosmetic face and liner on each part. Flipping a print does not produce the opposite laminate assembly.

Keep narrow sections practical

Mark the narrowest neck and the smallest internal bend for feasibility review. Both can affect removal and the appearance of the cut edge.

Use an annotated placement mock-up to expose uncertainty. Buyers can compare where the tips fall before committing to a permanent tool.

Approve the pair as sold

Review a packed pair so the intended first piece, orientation cue and ability to remove the second piece are apparent.

Identify individual drawing revisions and the approved pairing revision on the buyer's sample record. Update the set record when one outline changes.

Frequently asked questions

Can a single die serve both sides?

It depends on the symmetry, orientation and converting route. Review the actual construction with the converter.

References

Share this requirement with our team

Share the proposed outline, target areas, drawing revision and any prototype acceptance criteria.