• Custom shape feasibility
  • Drawing and liner review
  • Prototype acceptance planning

Choose a relief cut or a split cheek-patch layout

A cheek contour may need to wrap around more than one bend. A relief cut lets one sheet open locally. Dividing the shape into two pieces gives the user a second placement step. Those options lead to different carrier layouts and pack counts.

Compare an equal coverage area

Draw the intended boundary once, then make a slotted version and a divided version from that outline. Place each on the same three-dimensional form. Note where adjacent edges overlap and whether either piece lifts when the next one is positioned. Keep the shape reference and the tested material written on the photo so another reviewer can repeat the comparison.

Follow the part back to the pack

Lift each version from its carrier using the intended pickup point. Check if an exposed corner catches the next piece. For a two-piece layout, decide whether a pair belongs on one carrier or in separate cavities and show that count on the pack brief. For a slotted part, have the converter review the end of the cut and the remaining material beside it.

Frequently asked questions

Which version should go into the quote?

Quote the layout that matches the handling sequence you approved and include the alternative separately if a comparison is still needed.

References

Share this requirement with our team

Share the proposed outline, target areas, drawing revision and any prototype acceptance criteria.