• Custom shape feasibility
  • Drawing and liner review
  • Prototype acceptance planning

Set reference points for measuring a curved patch

A rounded tip is easy to point to on a picture and hard to locate in exactly the same place twice. Before two suppliers compare measurements, agree how the patch will be oriented and which feature establishes the starting position.

Use features the reviewer can locate

On a drawing of a crescent, point out the baseline used to set rotation and the feature that sets horizontal position. If the check is performed on a carrier, state whether the sheet edge or the patch controls the alignment. An offset measured from the sheet edge answers a placement question. The same offset measured from the part edge answers a question about the part itself.

Try the written instructions

Give another reviewer the drawing and a clean sample without the first reviewer's markings. Ask them to reproduce the setup and identify the two endpoints of the measurement. If the reviewers interpret an endpoint differently, revise the drawing callout or supply an annotated fixture view. Photograph the agreed orientation and retain it with the inspection version.

Frequently asked questions

Can an outline overlay serve as the reference?

Yes, when its scale and alignment features are defined and the sample is supported as specified. Mark the comparison region clearly.

References

Share this requirement with our team

Share the proposed outline, target areas, drawing revision and any prototype acceptance criteria.