• Custom shape feasibility
  • Drawing and liner review
  • Prototype acceptance planning

Patch Coverage Area and Adhesive Margins

A drawing can show three outlines on top of one another. Reviewers need to know which edge represents the cosmetic area, the adhesive boundary and the outside of the part.

Draw the layers separately

Put the visible outline, product zone and adhesive area on named drawing layers. Use line styles that still make sense in a grayscale copy.

Define margin as the spacing between a chosen pair of edges. Where those edges run on a curve, name the position and the measurement reference point.

Inspect the least favorable point

A wide straight section can hide a narrow region in the corner. Mark the positions expected to be closest under realistic placement variation.

Compare samples on their carrier and in the approved measurement state. Repositioning a flexible part before inspection can change the reading.

Record the margin decision

Check that the proposed drawing allows enough space for placement variation without crowding the product zone. Put uncertain dimensions on the open-issues list.

Send the layered drawing, area priority and pack concept with an inquiry. The project team can identify which measurements should control prototype review.

Frequently asked questions

Does a larger patch always give greater cosmetic coverage?

It may add backing area or clearance. Compare the actual product zone dimensions before drawing that conclusion.

References

Share this requirement with our team

Share the proposed outline, target areas, drawing revision and any prototype acceptance criteria.