• Custom shape feasibility
  • Drawing and liner review
  • Prototype acceptance planning

Specify a nose-patch bridge and wing cutout

A flat strip can look balanced on a drawing and still crease where the bridge changes direction. A buyer developing a cosmetic nose patch can identify that conflict early with two simple profiles and an inexpensive placement template.

Locate the bend first

Mark the centerline on a front-view sketch and mark where each wing should finish. On a side view, show the transition from bridge to wing. Give the converter the width across the finished part and a second dimension at the narrowest bridge. Label the view and outline revision on both sketches so the two measurements can be compared.

Decide which cut to investigate

Try a shallow relief and a deeper relief in paper under the same placement conditions. Photograph the same side of both samples and note whether the material overlaps, buckles or leaves a gap at the marked bend. Moving a cut toward the center may release one fold while creating an unsupported tip. Select a shape for a sample in the proposed material and ask for the cut edges to be reviewed on its carrier.

Frequently asked questions

What should accompany a nose-patch drawing?

A front view, a side reference and an annotated trial are enough to explain the geometry you want the supplier to review.

References

Share this requirement with our team

Share the proposed outline, target areas, drawing revision and any prototype acceptance criteria.