• Custom shape feasibility
  • Drawing and liner review
  • Prototype acceptance planning

How to specify a perforated release liner for patch sheets

Picture a sheet holding three pairs of eye patches. A customer should be able to tear off one pair while leaving the next pair covered. Send the converter a marked-up sheet showing exactly what should remain in the customer's hand.

Mark the tear path separately

On the drawing, distinguish the patch outline, the peel tab and the tear line. Mark the start edge, tear direction and clearance to the nearest patch. A section view should show whether the perforation passes through the liner alone or through other layers too.

Ask for two patterns on the intended material

Request the length of each cut and the uncut tie between cuts, and record the paper or film grade. Have the converter identify two feasible patterns. Compare them on the same material and thickness so a change of liner does not obscure the effect of the pattern.

Approve a sheet after handling

Remove a sheet from its pouch, separate a pair, then peel the patch. Note if the sheet separates prematurely, the tear wanders or an adjacent patch lifts. Photograph both sides, mark the sample revision and send the approved sheet with the tooling request.

References

Share this requirement with our team

Share the proposed outline, target areas, drawing revision and any prototype acceptance criteria.